Software Update -- FlyCast v1.22 available

[brwatters]

While Flycast v1.22 does appear to perform better than v.1.19 it has all but killed my use of it, I have reviewed my APN settings and my other WAP software works fine, I find that once I disable my cell phone radio and just leave WiFi enabled, reboot phone I can then get Flycast to fire up and work without issue, Once it loads once I can re-enable my phones radio and I am good to go, However this is not a solution, I was able to confirm this is a 1.22 issue as I was at one point able to dn/load v1.19 again and install and Flycast worked as it should, Of course that dn/load link has been now removed thus no turning back.

So I wonder if we will have a new build soon to resolve these issues?? .. This does not get fixed soon I think interest in this great effort will drop off.

BRW

[FlyCastRosco]

Please try the new candidate build (1.25) and see if that
works better for you.

What device and carrier are you using?

-Rosco

[hartlogan]

Hi, I have a BB 8830 from Alltel. I have installed v1.22 but when I click on the icon it states "We can't access your connection. Please verify your connection ". I have turned off my BB as well as taken out the batteries and replaced them. I still keep getting the same error message. Can you please help me resolve this issue? Thanks.

Leave the APN setting blank and click "send". It'll then allow you to login, methinks.

[glm97229]

I have new Curve v4.5.0.77. What build do I need (1.22 - 1.29?) to listen to the country stations. I can't get IO Alt, or several others very long. Lots of cut outs while still showing playing. Verizon is my carrier...

[FlyCastRosco]

Version 1.29 is probably the better one to install.
Have you tried any of the lower bit rate stations?
Showing Playing but no music is usually an indication
that we are not able to buffer enough audio to keep
the media player playing, but we haven't lost the
connection or had an error.

-Rosco